The BioLock 2 is a access validator with a stand-alone configuration and operation. To configure it, you do not need any access control software, just use its infrared controller.
This device is able to validate previously registered fingerprints and only these fingerprints can activate the internal relay and open the door. Depending on the version, the BioLock 2 may also validate RFID cards.
With the BioLock 2 infrared controller you can:
This product is available in these versions:
The BioLock 2 is designed to be installed inside a wall switch box (standard EU 70 mm), leaving only a surface area of approximately 8 mm outside the wall.
The fact that all electronics are embedded inside the wall, in addition to increasing the security level of the access system, also gives the product an attractive and elegant design, so that it can be applied even in cases where they are required high architectural standards.
This BioLock 2 is a built-in/embed installation version. Another version of this device, with identical functionalities, is also available in a external version, differing only in terms of design and ease of installation.
Features: